GLM and Lightning Cast

The GLM parallax showed up again Thursday, June 16th, over the PBZ area. This was even more evident than yesterday’s event in WI that was written about in a blog post.  Figure 1 has ProbSevere, LightningCast, GLM Flash Extent Density, and ENTLN data overlaid in a 4-panel.  This case was fairly simple to “self correct” the parallax as the GLM was clearly displaced to the north of ProbSevere (as well as the base reflectivity).  Really once you get a few cases under your belt recognizing the parallax, it’s not too challenging to keep that “self correct” in the back of your mind.  One interesting thing to note about Figure 1 is the storm just outside the PBZ CWA just south of Mount Veron, Ohio (See bottom left in Figure 1).  The ProbSevere and GLM FED are lined up perfectly and this is a great example of utilizing the lower threshold in the colormap. The bullseye shows up much nicer than the larger thresholds in the top two images.

Figure 1: GLM with ProbSevere and LightningCast

– Podium

What’s the best way to look at NUCAPS?

So far this week, I’ve been impressed with the performance of NUCAPS and for the most part Modified NUCAPS with providing thermodynamic profile information in areas that there are overpasses.  However, what would be the best setup to figure out how well NUCAPS is doing.  Let’s dive in:

Today we’re located in Binghamton, NY (BGM) office with a Enhanced risk over the region.  We’ve also got a NUCAPS sounding directly over the region which can help us with evaluating how well things like the SPC Mesoanalysis graphics or other models are doing:

But, visible satellite shows that there are some clouds that could be interfering with the retrievals:

After playing around a bit, it may be a good idea to load the Day Cloud Phase RGB, NUCAPS points, and surface observations into one pane:

This is useful for three reasons:

 

  1. We can see that the red in the Day Cloud Phase are mainly high clouds that are pretty thin and has enough gaps to allow for good retrievals underneath the cirrus.
  2. The low clouds are pretty thin except over the southern part of the CWA where some of the retrievals are yellow indicating that caution should be taken when looking at the profiles
  3. The surface observations can be used to give an idea of how well the surface T/Td are in the soundings which will impact all of the convective parameter calculations (especially CAPE/CIN)

 

So what about the soundings?  Looking at the NUCAPS and Modified NUCAPS here:

We can see how things are handled by the soundings.

Here is the original NUCAPS sounding at this point:

Of note, the surface conditions in the NUCAPS sounding is too warm (85 vs 80 at the nearest ob) while the Td were fairly close 69 vs 70.  How did the modified NUCAPS do?

80/70 in the sounding which is a much more likely scenario based on surface observations closest to the time of the overpass/sounding.

Why is this important?  Well, all your convective parameters are based on these two conditions.  MLCAPE drops by around 400 J/kg (~3900 J/kg vs ~3500 J/kg) AND CIN increases from -19 J/kg in the unmodified to -49 J/kg in the modified NUCAPS.  This too lines up with what the visible satellite shows; a lack of boundary layer CU potentially meaning the CAP is holding strong.

-Pym

ProbSevere V3 Adjusting During New Cell Formation

ProbSevere V3 has been showing much improvement over version two, with this particular day featuring somewhat pusley mixed-mode storms across upstate New York. This particular group of cells had habitual new updraft development, with storms nearing or briefly becoming severe as high dBZ cores develop aloof then make their way downward. These particular cells were able to form 1.00” hail. The ProbSevere V3 time series reflected the marginally severe nature of these storms very well, with values peaking at 60 to 65%. The very encouraging sign was the peaks and valleys in the ProbSevere V3 time series that showed this group of cells peaking at over 50% severe probabilities, dipping below 50% as the new updraft takes over, and then once again peaking above 50% once the new updraft strengthened. I’d definitely recommend forecasters to take a look at the timeseries to build confidence in cell trends during warning applications.

Shown above is the group of cells, with the initial one showing a core of 60+ dBZ that begins to drift off to the northwest while a newer updraft takes over and moves more east-northeast.

– aerobeaver

ProbSevere Time Series

I utilized the ProbSevere Time Series in warning operations today (June 16, 2022) within the Pittsburgh, PA CWA.  With only using basic radar products and no other products  (that I’d normally use during warning operations), it was extremely helpful in warning decision making.  After issuing several warnings already and monitoring a storm quickly developing in the western portions of the CWA that was getting close to severe, I issued a warning based on an uptick in the ProbSevere Time Series (See Figure 1 vs Figure 2).  The uptick in ProbHail occurred within about 5-6 minutes or roughly 2 radar scans of the PBZ WSR-88D prompted a warning.  The storm continued for several minutes and regenerated about 30 minutes later that prompted another warning downstream (See Figure 3).

Figure 1: ProbSevere Time Series at 2056z

Figure 2: ProbSevere Time Series at 2100z

Figure 3: ProbSevere Time Series Plots.

– Podium

NUCAPS sounding comparison vs observed 19z PIT sounding.

With the threat for severe weather today, WFO Pittsburg launched a 19z special sounding to access the atmosphere. The atmosphere featured a moist boundary layer with dewpoints the lower 70s and decent lapse rates throughout much of the atmosphere of around 7 C/km. The low-level wind profile in the observed sounding indicates veering winds with height and low level winds generally from the west southwest to west. The wind profile was helpful in determining the severe weather threat. Based on this low-level wind profile, one can conclude that the tornado threat appears to be fairly low.

There was also a NUCAPS pass across the region around 1741 UTC. I selected a point just to the west of the Pittsburgh office based on the general atmosphere advection to the west based on the observed sounding. Due to this, it would seem that the point just to the west of Pittsburgh at 1741 UTC would be a good approximation of the atmosphere near the Pittsburgh area at the time of the 19 UTC sounding.

The Observed sounding indicates major fluctuations in the dewpoint temperature throughout the atmosphere but the NUCAPs sounding indicates a much smoother moisture profile. Overall, these different methods indicate rather similar PW values to the observed around 1.31 inches and NUCAPS PW of 1.27 inches. Overall, a fairly consistent moisture profile. There are some noticeable differences in the boundary layer moisture profile. The modified NUCAPS is included as the last image. It seems that the modified NUCAPS introduces a bit too much moisture with PW values of 1.43 inches. These higher PW values also lead to higher values of instability as well.

Overall, the NUCAPS sounding was helpful in diagnosing the thermodynamic profile of the atmosphere. It also arrived over an hour earlier than the observed sounding. The sounding indicates a moderately unstable atmosphere across the region capable of leading to severe weather. The moisture profile is smoother in the NUCAPs but it doesn’t seem to affect the overall moisture with PW values being the same. It would be nice to add a model wind profile to the NUCAPs sounding. This way it would be possible to access the tornado threat as well because there is not much available in the thermodynamic profile alone to make this assessment. However, I’m very impressed by the similarity between the NUCAPs and observed sounding.

Observed 19 UTC PIT sounding and NUCAPS from 1741 UTC.

19 UTC PIT Observed Sounding

Location of Observed 19z PIT sounding.

1741 UTC NUCAPS Sounding.

1741 UTC NUCAPS soundings point, brighter green dot.

1741 UTC Modified NUCAPS.

– Marty McFly

Observations from BUF on Thursday June 16th

Optical Flow Wind Storm Top Divergence Can Aid in Warning Operations

The storm of the day produced a 2.5” hail stone near Cato, NY.
Strong storm top divergence signals an intense or intensifying thunderstorm. Matched with upper level radar scans, satellite interrogation (clean IR), and ProbSevere, optical flow wind products may be another tool to aid the warning forecaster and/or storm scale mesoanalysis,  Below are the corresponding optical flow wind storm top divergence images approaching 4 PM EDT (3 PM CDT) when the sig severe hail was reported. The thunderstorm of interest is centered just south of eastern Lake Ontario.

LightningCast as Graphical Messaging/IDSS Tool

As the DSS and graphics person for BUF, I took the opportunity to highlight the utility of LightningCast for Graphical NowCasts and DSS graphics. The fairly broad brushed nature of the lightning probability contours at the timesteps utilized for graphics I think is a positive for a few reasons: they show actionable probabilities (10+, 25+, 50+, 75+) that users can understand; the contours are akin to annotations on a radar graphic, so would be a time saver; and finally, broad brushed is a way to prompt users and partners to seek out more information, like real time zoomed in radar data, perhaps calling or sending us a chat on NWSChat, or even simply keeping an eye on the sky and listening for thunder. The parallax corrected product in the images below I feel would be more useful for graphics of the nature shown below. Ultimately, for operational use, there would probably need to be some work done to ensure they are not confusing to the user and aesthetically pleasing.
Graphical NowCasts for our websites and social media
Graphic for IDSS Event

A Case for the Sharpened GLM FED Color Scale Used this Week

Over the course of satellite product interrogation this week, the GLM FED stood out as one of the most useful products.  Below are examples from in/near the BUF CWA at 2043z and 2047z. Note that the top of the color scale was set to 128 flashes/5 min over the grid point vs. the default 256 flashes/5 min in AWIPS. The FED also paired well with the MFA and TOE on this 4-pane procedure.
The color curve used this week really popped and correlated well with frequent ENTLN detections. Another example below from shortly after 6 PM EDT (2202 and 2207z)  shows that there will be instances where perhaps an even small color bar range would be useful.
While the strongest storm at this time still showed up well on the AWIPS default color bar range, the 128 flashes/5 min top end of the range (top right) helped it pop even more and corresponded well conceptually with the ENTLN cloud flash detections. Furthermore, the thunderstorms to the north of the strongest thunderstorm showed up better from an SA perspective, if you have been focusing on the strongest storm for warning ops. The smallest color bar range on the bottom left further enhances the above described effect.

Addendum: GLM Flashes and a more smoothed FED

The excellent COD NexLab Satellite and Radar page added within the past year the GLM flash centroids to their GOES derived overlays. From an apples to apples perspective with respect to the ground based lightning detection network displays, this may be a useful product to add into AWIPS.
\

Addendum 2: Would a more smoothed FED be preferable?

Below are a few web based examples of FED displays.
A case can be made that these smoothed FED examples would be somewhat less obtrusive than the default AWIPS FED display, especially for storm scale interrogation by the warning operator or storm scale mesoanalyst.
– Hurricane84

GLM & Prob Severe in Low Radar Coverage

With the Buffalo CWA being a long and narrow forecast area, there are areas where the Buffalo Radar doesn’t provide good coverage. On a day like today where their second radar (KTYX) isn’t providing any data, the entire eastern half of the CWA has the Buffalo radar hitting storms at 20 kft or higher. This meant that we had to more heavily rely on Satellite data for warning operations.

Looking at the northeast corner of the CWA we had convection popping for a few hours along a frontal boundary. Being able to look at spikes in the GLM over time and Prob Severe time scales and just instances in the Prob Severe were very helpful with determining what was going on in the lower levels that weren’t visible on radar. As one storm over the lake begins to move inland there is a jump in the GLM and Prob Severe.

Being able to see the upward trends in time with the prob severe over time and then the increasing GLM was a big confidence boost to put out a warning.

-Cirrus Fields

Gridded NUCAPS Cross Sections

It took until the end of the week to think of trying this, but it turns out that the AWIPS cross section tool works with gridded NUCAPS (and it turns out some folks have already been using it). Mainly this suggests the usefulness of gridded NUCAPS at spatially comparing many sounding points (rather than the somewhat klunkly process of loading many soundings into NSHARP).

Here’s the cross section used to sample the ~1730Z NOAA20 NUCAPS soundings (lineB). Initially I thought the cross section would actually interpolate the 7 sounding points, but later I realized that the griddedNUCAPS would be sampled across the lineB.

The AWIPS volume browser (in cross section mode) allowed me to select griddednucaps as the source, and then both native and several derived parameters for display, and then of course the baseline (i.e. lineB) along which to calculate the cross section.

The main challenge with this workflow is knowing to find the exact time where your griddedNUCAPS is valid.  I loaded up griddedNUCAPS in a regular D2D panel to see that it was valid at 1730Z, then I increased the framecount of my cross section enough to allow me to step back in time to that point. Then, voila… I was able to plot images and/or contours across the line I’d drawn on the map.

Above: Cross-section of griddednucaps over ~7 sounding points, showing dewpoint as both image and contour

Above: Cross-section of griddednucaps over ~7 sounding points, showing dewpoint as image and lapse-rate as contour

Above: Cross-section of griddednucaps over ~7 sounding points, showing Temperature as image and relative humidity as contour

– Buzz Lightyear

Which GLM Color Scale is Best?

One of the easiest ways to get an argument…I mean discussion…going among AWIPS users is color tables.

However, in this case it does pose an interesting thought experiment because the color table isn’t changing but the scaling is.  Case in point, look at a line of tornadic supercells across Wisconsin from the GOES East GLM:

Changing the range of the color table helps pull out some details with low flash rate storms.  Although the northern storms have some higher flash rates and can be seen when the scale is set to the default (260), the southern storms with a lower flash rate can pull out more details with the lower maximum point (60).

Others this week have come up with some great ideas; developing a climatology for FED to know what the best ranges would be for the display for a given season, event type, etc.  Another thing to look at is how to best develop a table for the logarithmic scale that is used with FED with a different or wider color range.

– Hank Pym